Pipes

This is the Pipes series of 3d models. These are formed by taking the 2d 'vowel' shapes from the Bones series and successfully folding them against themselves. These parts assemble into the Silo and Well.

Download Complete Sets

Designer Notes

Use your slicing software to orient parts in 3d space and on the printer bed as needed.

The various dots should be split off into their own prints. Dots are normally not printed with support material. They risk being filled with support material and becoming useless after the print.

Use part numbers to track printing process.

Most parts should be at high infill, say 80 percent. Bases should be at least 25 percent infill. Higher infill will increase the strength of the legs in the bases.

Use 15 lb monofilament line with very small drops of super glue to anchor and support the various dots.

Plastics Used

Download Individual Parts